pkall remote start wire color do not match

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116294
Printed Date: May 16, 2025 at 1:30 AM

Topic: pkall remote start wire color do not match

Posted By: blancoloco412
Subject: pkall remote start wire color do not match
Date Posted: September 13, 2009 at 10:25 AM

Hi everyone I need some insight. I've searched everywhere but seem to find anyone who was come accross this. So I by the Pkall for the RS on 99 Accord. So I go over the manual and notice that on connector 2 none of the wire colors on the connector match the colors described in the manual. I could go off by wire location instead of color but don't want to go through all of that and it not work or even worse damage something.

Any help or guidance would be greatly appreciated.

-------------
BBB

Replies:

Posted By: tommy...
Date Posted: September 13, 2009 at 1:09 PM

This is a different bypass...But are these the wires you have...? https://www.bypasskit.com/getdocument.aspx?documentid=443

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Posted By: yimke
Date Posted: September 14, 2009 at 10:13 PM

ALWAYS go by pin location NOT color. But test to verify.

Posted By: blancoloco412
Date Posted: September 14, 2009 at 10:37 PM

thanks guys I went by location and it worked out good was just a little unsure of the location of one of the connector but it worked so I'm leaving it alone

-------------
BBB

Print Page | Close Window