remote start on 2000 mustang

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116412
Printed Date: July 06, 2025 at 11:34 PM

Topic: remote start on 2000 mustang

Posted By: Atl_monte
Subject: remote start on 2000 mustang
Date Posted: September 19, 2009 at 10:26 AM

I was working on installing an Clifford remote start on a v6 2000 Ford Mustang and was trying to locate the wire for the tach input, the wiring diagram says its a light GREEN / WHITE wire in the passenger kick panel but Im unable to locate a wire that fits that discription

Replies:

Posted By: chev104275
Date Posted: September 19, 2009 at 12:12 PM

2000 Ford Mustang Alarm, Remote Starter

Tach Light GREEN / WHITE Power Control Module behind right Kick

TACH Any wire that is NOT RED or WHITE/ LIGHT BLUE @ any IGNITON COIL or FUEL INJECTORS

-------------
If i Can't Install it I Don't need it Joe

Posted By: Atl_monte
Date Posted: September 19, 2009 at 12:37 PM

chev104275 wrote:

2000 Ford Mustang Alarm, Remote Starter

Tach Light GREEN / WHITE Power Control Module behind right Kick

TACH Any wire that is NOT RED or WHITE/ LIGHT BLUE @ any IGNITON COIL or FUEL INJECTORS

found a GREEN / WHITE wire in kick but it didn't show any RPM when I connected a dwell/rpm meter

Posted By: chev104275
Date Posted: September 19, 2009 at 12:47 PM

looks like you could use BROWN / yellow pin 74 or white pin 101 or tan pin 75 or BROWN / light blue pin 100 or tan/black pin 73 or light GREEN/ orange pin 99 any or those should work for you there all at the pcm they are the pulses to the fuel injectors

-------------
If i Can't Install it I Don't need it Joe

Print Page | Close Window