programing tach
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=11653
Printed Date: May 05, 2024 at 1:33 AM
Topic: programing tach
Posted By: gmando
Subject: programing tach
Date Posted: March 30, 2003 at 8:51 PM
I am having some difficulty programming the tach for a prestige alarm. Im installing in a Ram 1500 2003 with 4.7. I received a diagram of the wiring and tagged the GREEN/ orange wire but the alarm does not seem to allow the programing. I am installing a prestige 995. Any advice would help.
Replies:
Posted By: CruisinS&S
Date Posted: March 31, 2003 at 8:33 AM
-First off make sure that the unit receives the remote start activation
-does the parking lights flash 7 times when you try to remote start with remote?(If not the unit is not getting a signal
-Also make sure that the remote start valet switch is plugged into the right place. There is an orange plug and a red plug on the unit-you need the red plug!
-To program Tach-Put key in ignition turn to run push valet/program button 3 timmes (should get a confirmation chirp) turn key to off hold button in then start car. Parking lights should flash to confirm then take finger off button parking lights should stay solid
Good Luck
------------- Cruisin Security And Sounds
|