wanting auto locks
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116954
Printed Date: July 12, 2025 at 3:20 PM
Topic: wanting auto locks
Posted By: lr383
Subject: wanting auto locks
Date Posted: October 14, 2009 at 12:15 PM
Is there any way to get my doors to lock right after I start going ? I have a Nissan pathfinder 2006 with a stock alarm its for sec. for my wife . stock alarm does not have this opt. Or would a after market alarm be better than stock?
Replies:
Posted By: howie ll
Date Posted: October 14, 2009 at 12:33 PM
Go to the relay section on this site.
Posted By: i am an idiot
Date Posted: October 14, 2009 at 2:16 PM
Posted By: lr383
Date Posted: October 14, 2009 at 5:37 PM
Is the resistor between 86 and 85 10k? so you just attach between them?From the dia. it looks like that. Thank you for your replys.
Posted By: i am an idiot
Date Posted: October 14, 2009 at 5:47 PM
That is a diode. 1N4001, or greater. Available at Radio Shack.
Posted By: lr383
Date Posted: October 25, 2009 at 1:00 AM
Can any of you help me . I am engine guy I look at the dia. and got the resistors 1/2 watt and a in4001 diode They had 1/4 watt but I Didn't know if bigger was better.Also got 1000 k capacitors . Do you solder these as the dia. shows with out any supports ? Probable a stupid question for you guys but bear me.An what size wire do you use to connect the relays. On the door trigger is that the door switch I think? How do you control the time before the door locks? Is it in the capacitor? Again thank you for your time Iam learning a lot reading your reply's.
Posted By: howie ll
Date Posted: October 25, 2009 at 2:39 AM
1/4 watt or bigger doesn't matter. Once you've soldered loom up (after testing) with Scotch 33+ and cable (zip) ties, can't help you with the wire guage, we use metric, up to 1.5mm. I think that's 14g. The locking will be almost instant, maybe Mr.I can help you with that or something like a DEI 528t or another cap as a time delay. Not familiar with vehicle, wouldn't think you need the switch and yes an aftermarket alarm would have this facility.
Posted By: howie ll
Date Posted: October 25, 2009 at 2:43 AM
Lt.Blue lock (neg) and grey unlock (neg) in driver's kick panel, double unlock pulse needed to unlock other doors so 1 more relay for the second pulse, although if people are in the vehicle I don't think it matters, they can use a hand to undo, also safer if kids or use the drivers door button for the other doors. So don't ask about the switch in the driver's door not needed.
|