Print Page | Close Window

08 4 runner

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117032
Printed Date: May 28, 2024 at 10:07 PM


Topic: 08 4 runner

Posted By: 1caraudioman
Subject: 08 4 runner
Date Posted: October 17, 2009 at 2:42 PM

anyone done the back window off a after market alarm? if so how??



Replies:

Posted By: i am an idiot
Date Posted: October 17, 2009 at 9:31 PM
If the vehicle has a light on the dash that tells you the glass is open, it should be pretty easy.  You will have to figure out where the switch is located.  Chances are it will be in the latch that the glass locks into.  There should not be that many wires going into the door.  Using an Ohm meter, check the resistance from each wire in the harness to ground.  With the window open or unlatched, it should be a very low resistance.  Close the glass and it should read very high resistance. 




Posted By: Chris Luongo
Date Posted: October 17, 2009 at 9:37 PM
Been covered here many times, both on the 4Runner and Sequoia....search feature should find it.





Print Page | Close Window