Print Page | Close Window

03 f 250 heated seats rs

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117197
Printed Date: July 16, 2025 at 8:50 AM


Topic: 03 f 250 heated seats rs

Posted By: localed
Subject: 03 f 250 heated seats rs
Date Posted: October 23, 2009 at 7:02 PM

what type of signal and where to do i need to activate heated seats during remote start? 03 f250 xlt lariat supercab .



Replies:

Posted By: tommy...
Date Posted: October 23, 2009 at 8:06 PM
Do you have a switch to turn them on...? I would start there...! Do you have a meter...? If the answer is NO to the second question...Buy one or take it to a shop...!

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!




Posted By: chev104275
Date Posted: October 24, 2009 at 8:01 AM
is there just an on and off switch for the heated seat ?   it looks like there is a dark GREEN/ violet that gets grounded through the switch to turn them on

-------------
If i Can't Install it    I Don't need it   Joe




Posted By: localed
Date Posted: October 24, 2009 at 6:48 PM
joe , there is a button on the side of the seat that you push and a led lights up beside it , the seat turns on and turns itself off after about 10 minutes and the led goes out. it will not turn back on unless you push the button again so it think there is a timer in the circuit, so do you think i could run a neg pulse from my trunk pop to the dkgn/vi wire ?

thanks alot , ed




Posted By: chriswallace187
Date Posted: October 24, 2009 at 7:21 PM
If you have either an auxiliary channel or a dedicated defroster output from your remote start available, and it can be programmed to send a momentary pulse, you can just connect that wire directly to the momentary wire from the switch(assuming it pulses (-), of course).

-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two




Posted By: localed
Date Posted: October 25, 2009 at 3:14 PM
my trunk pop output was (-) pulse , i ran a from it to the gn/vi wire at the switch , the heated seats work perfect. thanks alot joe and chris you were a great help.
   ed






Print Page | Close Window