Hey guys, I've installed a Viper 5101V on a Ford Fusion 2008 manual and DEI and I weren't able to pin point what the problem is. The Viper will not get into ready mode, it will not activation when pressing on the start button after making sure that the vehicule is in neutral with hand brake on. DEI and I tripple checked all the wiring, BLACK/ white is a hand brake switch, door triggers are positive thrue diodes and resistors cause it's an open state door trigger....ground is perfect...voltages are there...brake switch is working good, pin switch is not installed...did anyone of you had a simular problem they would like to share? I'm out of ideas....also, the main brain as been changed...The only thing that get into my head is to install a relay on the hand brake so that the BLACK/ white is seing a perfect steady ground cause the ground output of the hand brake switch gives me a 27 ohms impedance which is way too high for a ground.
-------------
Sylvain Rochon
MECP security specialist
Tech support for remote starters
26 Years of experience counts
I'm here to help.
Did you hook up the tach wire? Manual mode won't work with voltage check or virtual tach
-------------
Eric
Thanks for replying but I did find my problem and it's working great...
Cheers
-------------
Sylvain Rochon
MECP security specialist
Tech support for remote starters
26 Years of experience counts
I'm here to help.