dlpk, equinox delayed key crank
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117448
Printed Date: April 16, 2024 at 8:20 AM
Topic: dlpk, equinox delayed key crank
Posted By: brhaugen
Subject: dlpk, equinox delayed key crank
Date Posted: November 03, 2009 at 5:21 PM
Has anyone run across this?
I installed a DLPK on a 2008 Chev Equinox.
Everything works great - However not the customer complains that sometimes when she uses the key, there is a delay in when the starter cranks.
I understand how these cars crank, the computer sees the acc drop out and it activates the starter circuit.
How could the bypass cause a delay in this? Is there a problem with the bypass, my install?
Thanks in advance.....
-------------
Brent Haugen
Fargo, ND
Replies:
Posted By: metz35
Date Posted: November 03, 2009 at 8:10 PM
its the software in the bypass module had a similar problem with a PKG9 , thus why they dont make the PKG 9 anymore...
Posted By: brhaugen
Date Posted: November 04, 2009 at 6:17 AM
should I try to flash it with the latest firmware? I installed it right out of the package.
-------------
Brent Haugen
Fargo, ND
Posted By: metz35
Date Posted: November 04, 2009 at 3:35 PM
doesnt hurt to upgrade it, but more than likely it will do it still
Posted By: brhaugen
Date Posted: November 05, 2009 at 6:23 AM
FYI for anyone else who may run in to this issue:
I asked a FAQ question on bypasskit.com:
Q15334 - I installed one of these on a 08 Chev Equinox. The customer has informed me that some times there is a delay in the starter cranking now. Have you heard of this? Is this normal, is there an issue with the bypass/install. Please help.
Last update: 11/4/2009 9:01:59 AM Article has been viewed: 10
If you get this problem when you start the car with the key, use a RFLCHGM and connect it to the DLPK.
You will need to reconnect the brown or yellow wire that you did cut when you installed the DLPK.
Once everything is installed properly, the RFLCHGM will need to be programmed as shown in the installation sheet.
By the way, if you decide not to modify the install, the issue you get with the module is normal.
-------------
Brent Haugen
Fargo, ND
|