chevrolet malibu 2007 ls
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117526
Printed Date: July 05, 2025 at 8:06 AM
Topic: chevrolet malibu 2007 ls
Posted By: samirlife
Subject: chevrolet malibu 2007 ls
Date Posted: November 06, 2009 at 7:12 PM
I bought Viper-5901 remote start/security system and a separate express kit remote start bypass kit for my Chevy Malibu 07. Can someone help me figure out where the starter wires, factory alarm arm and disarm wires and trunk release wires are?
-------------
Sam
Replies:
Posted By: chriswallace187
Date Posted: November 07, 2009 at 3:40 AM
Start by reading this post. It's for an '05, but the wires are the same.
Factory alarm arm and disarm are going to be with the factory remote only, unless you're using a bypass that will control them - there aren't any wires on the vehicle that perform this function.
Which bypass are you using? ------------- C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: Chris Luongo
Date Posted: November 07, 2009 at 11:34 AM
The only area I would disagree with Chris, is that it seems that some of the newer Malibus do have a light green disarm wire. But no arm wire.
You can find pretty much all the wires you need, locks, trunk, disarm, a heavy-gauge constant wire, in the wiring harness that runs along the driver's door sill.
There are some ignition and accessory wires in the doorsill, but they don't seem to work for remote start......I get those at the ignition switch.
There is no traditional starter wire. When ignition turns on, and accessory drops power, the car cranks and starts.
Again, as Chris said, your module probably performs many of these functions for you......exactly what's the part number of the module you have?
|