2010 fusion/milan factory alarm inputs?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117580
Printed Date: May 06, 2024 at 3:21 AM
Topic: 2010 fusion/milan factory alarm inputs?
Posted By: angelars
Subject: 2010 fusion/milan factory alarm inputs?
Date Posted: November 08, 2009 at 8:36 PM
Installing a Viper 5902 into a 2010 Mercury Milan (but the Ford Fusion has the same wiring).
Door lock/unlock, illuminated entry, and parking light flash are all via a button on the ignition key (for the factory PATS alarm).
The Viper 5901/5902 has OEM factory alarm/disarm wires (H2/1 and H2/3).
What wires on the Milan/Fusion do we tap into, so that we can control the factory alarm via the Viper alarm?
Replies:
Posted By: big sexy lac
Date Posted: November 08, 2009 at 10:01 PM
Factory alarm arm - arms on lock with door open
Factory alarm disarm - factory remote only
Disarm no unlock - pats transponder & ignition
Keysense - blue/gray +
That's all I have hope it helps
-------------
WELL?
Posted By: chriswallace187
Date Posted: November 09, 2009 at 1:32 AM
According to Audiovox, disarm should be yellow/gray (-) at the SJB. They're also showing lock as blue (-) at the SJB, and LF door as GREEN/ violet (-) also at SJB; however if I remember right the door trigger might be an open state. Meter to verify, as always.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
|