command start cs310i programing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117620
Printed Date: June 18, 2025 at 10:28 AM

Topic: command start cs310i programing

Posted By: lnagy
Subject: command start cs310i programing
Date Posted: November 10, 2009 at 8:05 AM

I have command start remote starter cs310i and I am in need of the programming manual

I purchased a used 2002 Buick rendezvous with this starter in it.

I need the programming instructions for this starter to reprogram the tach input

Your site is great because I found the wiring for this starter on your site

Thanks

Replies:

Posted By: chadwa2003
Date Posted: November 10, 2009 at 8:33 AM

it should be that you flash the hood pin then push and hold the brake and press the lock and unlock buttons on the remote. parking lights should flash 5 times. Then start the vehicle with the key allow it to get to regular idle at which point you will push and hold the brake pedal and the parking lights should flash 5 times to confirm tach programming has been completed

Posted By: lnagy
Date Posted: November 10, 2009 at 9:16 AM

Thanks chadwa2003 for the info

I will give that a try tonight when I get home

Posted By: Velocity Motors
Date Posted: November 10, 2009 at 11:17 PM

The CS310i requires it be done manually through the options programming. It's a PITA but here is the programming sheet.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: lnagy
Date Posted: November 11, 2009 at 11:40 AM

I am still having problems - I can now get into the programing - the parklights flash as they should. My main problem is the buick will start - run for 4 secs and stop.I have the programming for 270i and the 290i and they are different. My remote is a 4 button and i used lock as 1, unlock as 2, and start as button 3. my command start is a cs-310i and i have never seen the programming sheet for this model. It is my understanding from reading the forums that the cs300i and the cs310i are the same.I put the 270i default program in and then the buick would not start but the locks still worked.I then put the 290i program in and we are back to my starting problem of the buick starting -running for 4 secs-and stopping.
Your help is appeciated
My email is l.nagy@sasktel.net if anyone has a programming manual