Print Page | Close Window

2004 bonneville gxp w/autostart 2600

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117729
Printed Date: May 17, 2025 at 7:50 AM


Topic: 2004 bonneville gxp w/autostart 2600

Posted By: mtshowdown
Subject: 2004 bonneville gxp w/autostart 2600
Date Posted: November 14, 2009 at 4:08 PM

Installing an autostart 2600 remote starter with an Idata ADS-DLSL GM. The driver door unlocks with 1st command will not unlock remaining doors with second command. Hard wired the 2600 to the idata module, did not connect the door/trunk status output from the idata module (not sure where to connect this), did connect the door lock, unlock input and the trunk input. The doors unlock correctly with the factory fob. Any help would be appreciated. Thank you.



Replies:

Posted By: mtshowdown
Date Posted: November 14, 2009 at 5:41 PM

Additional information. When I tap into the unlock wire between the idata and starter control ( green wire on the autostart 2600 12 pin and blue/black wire on the idata 10 pin), touch it to ground twice all doors unlock as they should. This tells me that the problem is with the autostart 2600 controller not sending the second pulse or I need to connect the idata green door/trunk status output somewhere (possible needed to let the autostart know the 1st pulse was executed).  Any ideas? Thank you.


Print Page | Close Window