Print Page | Close Window

bulldog security

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117858
Printed Date: May 18, 2025 at 9:07 PM


Topic: bulldog security

Posted By: alan bindrup
Subject: bulldog security
Date Posted: November 19, 2009 at 1:01 PM

I've installed a Bulldog Security remote start, along with a PKUCG2X bypass into my 2008 Dodge Ram half ton gasoline fueled hemi. Everything works, (ignition on and off, lights, doorlocks, etc.), but she will not crank the starter. I am getting a ground trigger out of the bypass to the MUX wire aat the keyswitch, but it must be the wrong value. Does anyone know if I need to add a resistor and what value?

Thanks 



-------------
AL



Replies:

Posted By: dasbogie
Date Posted: November 19, 2009 at 2:14 PM
did you program for tach or voltage?



Posted By: alan bindrup
Date Posted: November 19, 2009 at 5:41 PM
No tach input.

-------------
AL



Posted By: dasbogie
Date Posted: November 19, 2009 at 9:14 PM
does your bulldog support shutdown diagnostics?  if so check it.  do you have a hoodpin hooked up?  make sure it's not seeing ground when remtoe starting. 



Posted By: alan bindrup
Date Posted: November 19, 2009 at 9:28 PM

I haven't seen anything on shutdown diagnostics. Factory tech support is non-existent. Haven't hooked up the hood pin. I'm pretty sure that the module is sending the wrong type of signal to the computer to let it crank the starter. Ignition powers up, and shuts down, as it should. Just no starter crank  yet.

Thanks



-------------
AL


Print Page | Close Window