hi guys, i have a 99 dodge ram 5.9l 4x4 with not keyless entry but it have electric power locks, i got a AutoCommand remote car starter 41027T with alarm and i got all the wiring to work starter lights horn tach, but i can't get the door to work with the keyless entry from the system, can you guys healp me how to wiring my doors, the autocommand puts out - negative for the door.
any healp.
thx guys.
You have a Rev polarity circut. (5 wire hook up) You will need two relays _ tape them together
You will put 12v on 86 and 87 on both relays---- you will put the lock out of the alarm to 85 on one relay and unlock to the other 85 on the 2nd relay..... Now find you lock wire in the drivers kick panel orange with a purple stripe... cut that wire in half take the wire going to the switch (going towards the drivers door) to 87a on the relay that you put the lock wire coming from the alarm, and put the otherside of the wire you cut to 30 on the same relay.. Now find the unlock wire pink with a purple stripe..will also be in the drivers side kick... cut that wire in half and do the samr for the other side.. you might want to test the wires and make sure the swich side goes to the 87a Hope this helps
hi, i did tried that and the only thing i got is a buss sound from the relays, i got 2 (from auto zone) 5 pin flasher relays you think that is the problem.
and if a leave the relay and all the wires conected the door switch won't work to.
any ideas?.
tried other relays?
or you guys have some name for the relays.
thx
