I have an '01 Dodge ram Diesel auto with keyless entry. I've installed a viper 5901 alarm/remote start and seem to have everything working except for the door locks. I tried using the 5 wire reverse polarity diagram and when I hit the lock/unlock button on the remote, the truck does just the opposite. I've switched wires around with no luck. I did check the wires at the switch and noticed I have two wires that are 12v+ when I hit the switch, each at a time. I also have a contstant power supply and a BLACK/ green stripe wire that I imagine is a ground, but doesnt seem to do anything. That being said, I tried wiring using the 3 wire relay system with no luck. During all of this, the door panel switch works fine. I do have the alarm arm/disarm hooked up to a single wire and I'm using a 1500 and 644 resistor as listed in the alarm install directions.
Any help is greatly appreciated.
you should be going to the keyless module and not wiring the reverse lock method. heres the info i got if you need the picts to find it message me and i will send it to you.
Lock = 670 Ohms Unlock 1.5 Kohms to neg pulse, first unlock will only disarm and trig the dome light but it's not
gonna unlock the Truck. program the unit for double pulse unlock. .If no keyyless on the truck door lock are
ORANGE / Purple (Rev) and Pink/Purple (Rev) in the driver's kick panel or the rubber jam boot from the driver's door.
KeyLess it's located a the right side of the steering collumn. with 2 green plug on it.