Print Page | Close Window

python 1601 mustang

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118077
Printed Date: May 16, 2025 at 4:10 AM


Topic: python 1601 mustang

Posted By: godshandkiller
Subject: python 1601 mustang
Date Posted: November 28, 2009 at 6:04 PM

im installing a python 1601 in my 2000 mustang gt i have the alarm and the door locks and trunk pop working fine but the wiring for the remote start is confusing me this is the wiring for my car
Constant 12V+Yellow or Light GREEN/ Purple Ignition Switch Harness 
StarterWHITE/ Pink Ignition Switch Harness 
IgnitionRED / Light Green Ignition Switch Harness 
Ignition 2Gray / YELLOW Ignition Switch Harness 
AccessoryGray / YELLOW Ignition Switch Harness 
and the wires on remote start harness,pink-ignition 1 (+)output,RED / white-fused 30a,orange accessory output,violet starter output,green starter input,red 12v constant fused 30 a input,pink/white flex relay output,pink/black flex relay contact 87a,RED / black fused 30a (for starter and accessory relays).any help would be appreciated



Replies:

Posted By: t&t tech
Date Posted: November 28, 2009 at 6:12 PM

RED / white, RED / black, and red all fuse at thirty amps connect to the ignition harness twelve volts constant,

Cut your WHITE/ pink starter wire in half, Green to the side from the keyswitch purple to the other side,

RED / light green connects to the pink wire from your relay,

gray / YELLOW, ignition two, to the pink/white

gray / YELLOW, accesory, to the orange wire,

isolate the pink/back not neccesary in this application!





Print Page | Close Window