gmdlbp interface

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118087
Printed Date: May 15, 2025 at 8:14 AM

Topic: gmdlbp interface

Posted By: rksterling
Subject: gmdlbp interface
Date Posted: November 28, 2009 at 11:49 PM

I am trying to wire a interface module - gmdlbp with a two way autostart AS-2361-TW installed in a 2004 chev silverado

On Bypass module gmdlbp I need to know where to connect these wires. The first three are shown to go the the starter, but I am not sure where.

Green (-) = Lock Input

Blue (-) = unlock Input

Violet/White = Connected to disarm wire from remote starter if oem alarm sounds

Orange (-) = Panic Input

Any help would be appreciatted,

Thanks in advance!

Replies:

Posted By: sparkie
Date Posted: November 29, 2009 at 7:35 PM

Connect the Green wire from the bypass to the Brown wire in the 12 pin harness, the Blue bypass wire to the Green wire in the 12 pin harness, the Brown bypass wire to the White wire in the the 12 pin harness, the Red bypass wire to a fused battery source and the Black bypass wire to ground. You can use the Orange wire for Panic activation if you want. If desired, connect it to the Blue wire in the 12 pin harness. This is usually for the trunk release, but you can then use the remote's trunk button as a panic button. The PURPLE / White won't be needed.

-------------
sparky

Print Page | Close Window