Print Page | Close Window

abs, brake light, 2003 dodge ram

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118190
Printed Date: May 14, 2025 at 5:45 PM


Topic: abs, brake light, 2003 dodge ram

Posted By: rp90cb7
Subject: abs, brake light, 2003 dodge ram
Date Posted: December 02, 2009 at 9:13 PM

working on a 2003 dodge ram every thing working fine but then the battery

went died, i charged  the battery now the brake and abs light come on with

the factory key. check the fuse under the hood ok is there some where else i can check

need help thanks



-------------
RP90CB7



Replies:

Posted By: metz35
Date Posted: December 02, 2009 at 9:25 PM
search the forum this has been answered multiple times.




Posted By: i am an idiot
Date Posted: December 02, 2009 at 9:42 PM
1500, 2500?  Did you install a remote start?




Posted By: rp90cb7
Date Posted: December 03, 2009 at 6:27 AM
it,s a 1500 and yes i installed remote starter

-------------
RP90CB7




Posted By: i am an idiot
Date Posted: December 03, 2009 at 6:58 AM
posted_imageBatteryRED /WHITE(+)IGNITION SWITCH HARNESSposted_image
posted_imageIgnition 1DRK. BLUE 16 GAUGE(+)IGNITION SWITCH HARNESS
posted_imageIgnition 21(+)IGNITION SWITCH HARNESSposted_image
posted_imageIgnition 3RED / WHITE(+)IGNITION SWITCH HARNESSposted_image
posted_imageAccessory 1BLACK/ WHITE(+)IGNITION SWITCH HARNESS
posted_imageAccessory 2BLACK/ ORANGE(+)IGNITION SWITCH HARNESS
posted_imageAccessory 3ORANGE(+)1500 ONLY
posted_imageStarter 1YELLOW(+)IGNITION SWITCH HARNESS
posted_imageAnti-Theft TypeDAIMLER SENTRY KEY® VEHICLE IMMOBILIZER
posted_imageAnti-Theft DescriptNONE
posted_imageKey SenseBLUE(-)IGNITION SWITCH HARNESS
posted_imageNeutral SafetyBLACK/ WHITE(-)IGNITION SWITCH HARNESS
posted_imageTachometerRED / BLACK(AC)AT COIL ON DRV.SIDE OF ENGINEposted_image
posted_imageWait To StartORANGE / BLACK
posted_imageSpeed SenseLIGHT GREEN / WHITE(AC)PIN 13 OF 38 PIN BLACK CONN
posted_imageParking LightsVIOLET / YELLOW(-)AT SWITCHposted_image
posted_imageBrake LightsWHITE/ TAN(+)AT BRAKE SWITCH
posted_imageReverse LightsVIOLET/BLACK(+)16 PIN GRY CONN DRIVERS DASH
posted_imageHornBLACK/ RED(-)74 PIN CONN BEHIND DR. DASH OR COLUMN

Note reads as follows:  GREEN & ORANGE ARE OFF DURING CRANK. BOTH NEED TO BE POWERED BY A RELAY FROM THE REMOTE START. RED / WHITE IS IGNITION 3 ON DURING CRANK. MUST USE LIGHT. BLUE (-) IGNITION 3 TO TRIGGER A RELAY.




Posted By: rp90cb7
Date Posted: December 03, 2009 at 7:57 AM

ok that fine but what i'm trying to say is that with the factory key in the ignition

to start the car the abs & brake light come on. also to the battery went died

after that, that's  when the lights came on



-------------
RP90CB7




Posted By: i am an idiot
Date Posted: December 03, 2009 at 8:06 AM
Does the light come on under remote start condition?  Did you connect Ignition 3 and accessory 3?




Posted By: rp90cb7
Date Posted: December 03, 2009 at 8:47 AM
it comes on with the key and the remote start

-------------
RP90CB7




Posted By: rp90cb7
Date Posted: December 03, 2009 at 10:47 AM

found the problem it the truck when the battery dies the two lights come on

and stay on until you drive it. but always check your work and then recheck again.

thanks for the help



-------------
RP90CB7




Posted By: i am an idiot
Date Posted: December 03, 2009 at 10:55 AM

Did you use reloys to isolate the 3 ignition and 3 accessory wires?  Do you have a green wire as mentioned in the note?  They show no wire color for Ign 2, I can only assume that it may be green. 

If you did not use relays to isolate the 3 wires, try removing the remote start from the equation to see if the vehicle behaves normally with the key.  If it does, you will have to either diode isolate (with some high current capacity diodes) or use relays.  Are the green and orange wires unpowered during start?






Print Page | Close Window