avistart 4113 remote start wiring
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118228
Printed Date: May 19, 2025 at 3:17 AM
Topic: avistart 4113 remote start wiring
Posted By: geekybiker
Subject: avistart 4113 remote start wiring
Date Posted: December 04, 2009 at 3:02 PM
I'm getting ready to install an Avital Avistart 4113 in a 2008 honda crv. I've been going through the install guide and vs the wiring diagram from direct wire and come up with a few questions on which wires go where. (I don't have access to directechs, I just got a printout with my order)I'm using a pkall d2d transponder kit with it.
Harness 1 (9 pin)
p3-Yellow goes to + ignition out. Supposedly the wire leading to the factory alarm. I don't see it on the diagram.
p4- WHITE/ blue -activation input I'm not sure what do with this. Is it a progamming input, does it goto the pkall?
h2 5 pin
p1 BLACK/ white says its supposed to go through a neutral safety switch. Its lised as NA on the diagram... Just skip this one?
Satellite harness (4 pin)
none of these have any description other than the diagram
p1 blue sa status output
p2 orange (-) say 2nd accessory turn on. Now there is a (+) 2nd accessory wire, but its also connected to the heavy gauge wireing.
Also the PKALL has a blue/white wire that is supposed to connect to the remote start unit somewhere. Anyone know where it goes?
thanks!
Replies:
Posted By: jim hunter
Date Posted: December 04, 2009 at 7:57 PM
yellow not used(only used if it has an aftermarket alarm to prevent triggering during remote start
WHITE/ blue-not used this is an auxillary input to activate remote start(if adding to an existing alarm/keyless etc
blk/white needs to see ground fro remote start to work, either ground it or wire it into a toggle switch for on/off shutdown
satellite 4 pin harness blue(status out) goes to bypass ground when running nput
other 3 wires not needed
bypass blue/white- what do the istructions say it goes to? if it says ground when running (which i think it is) it will go to this blue wire on 4 pin satellite harness(status out aka ground when running)
|