3rd ignition and 2nd acessory relay
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118245
Printed Date: May 16, 2024 at 8:28 AM
Topic: 3rd ignition and 2nd acessory relay
Posted By: rnemtb
Subject: 3rd ignition and 2nd acessory relay
Date Posted: December 05, 2009 at 6:57 AM
good morning,
i am installing a valet 562t remote start in my 1999 ford expedition eddie bauer with electronic climate control.i just need to check here to see if my relays are wired correctly for third ignition and second accessory before installing. below is what i have set up .
85 = 12v constant
87 = 12v constant
86 = - trigger from remote start
30 = to accessory or ignition
87a not used
i understand that i have to use all three ignition wires(in car)and the gray / YELLOW and BLACK/ green accessory wires due to the electronic climate controls. any help is appreciated
George
-------------
rnemtb
Replies:
Posted By: rnemtb
Date Posted: December 05, 2009 at 6:59 AM
i did a search here for my vehicle. and found the info in a close topic but want to be sure.
-------------
rnemtb
Posted By: chev104275
Date Posted: December 05, 2009 at 8:10 AM
the relay is right except swap 85 and 86 trigger to 85 and 12v to 86 make sure you fuse your 12v feed
-------------
If i Can't Install it I Don't need it Joe
Posted By: rnemtb
Date Posted: December 05, 2009 at 8:19 AM
thanks for the help. already fused.
-------------
rnemtb
|