Print Page | Close Window

what to do with spare channel wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118512
Printed Date: October 31, 2024 at 6:27 PM


Topic: what to do with spare channel wire

Posted By: slashman
Subject: what to do with spare channel wire
Date Posted: December 14, 2009 at 1:10 AM

Hi,

I'm currently doing a viper 791xv installation and at the moment I am not going to have any use for the extra channel outputs.  I will have 3 left over + the 2nd unlock output which I will eventually use but not right now.

What would be the best thing to do.  I was thinking of obtaining a connector plug that will accept 4 wires and then when it comes time to use them I'll just use another connector that plugs in.  It would be located under the dash in an easy to get to location.  Now this brings me to another question.

Can a thief do anything with these wires?

Thanks




Replies:

Posted By: howie ll
Date Posted: December 14, 2009 at 2:36 AM
Bundle the wires, plugged in to the unit to your cable run in a way you can get to the cables at the end, no to the last question.




Posted By: slashman
Date Posted: December 14, 2009 at 3:53 AM
Thanks, too easy. :)





Print Page | Close Window