does anyone have paperwork for an 05 Mazda 3. thank u in advance
-------------
Confidence is the key to any project!!
Security
WIRE COLOR POLARITY LOCATION
Battery BLACK/ RED (+) IGNITION SWITCH HARNESS
Ignition 1 GREEN/ YELLOW (+) IGNITION SWITCH HARNESS
Starter 1 GRAY/BLACK (+) IGNITION SWITCH HARNESS
All Door Trigger BLACK/ BLUE (-) AT MODULE NEAR GLOVEBOX TO LEFT OF PASSENGER FOOTWELL
PIN - U, PLUG #5
Domelight Super BLACK/ BLUE (-) AT MODULE NEAR GLOVEBOX TO LEFT OF PASSENGER FOOTWELL
PIN - U, PLUG #5
Trunk Trigger BLACK/ RED (-) AT MODULE NEAR GLOVEBOX TO LEFT OF PASSENGER FOOTWELL
PIN - Z, PLUG #6
Hood Trigger BLACK / YELLOW (-) AT MODULE NEAR GLOVEBOX TO LEFT OF PASSENGER FOOTWELL
PIN - Y, PLUG #2
Parking Lights BLACK/ WHITE (-) AT VEHICLE LIGHT SWITCH HARNESS
Remote Start
WIRE COLOR POLARITY LOCATION
Battery BLACK/ RED (+) IGNITION SWITCH HARNESS
Ignition 1 GREEN/ YELLOW (+) IGNITION SWITCH HARNESS
Ignition 2 PINK / YELLOW (+) IGNITION SWITCH HARNESS
Accessory 1 YELLOW (+) IGNITION SWITCH HARNESS
Starter 1 GRAY/BLACK (+) IGNITION SWITCH HARNESS
Anti-Theft Type UNIVERSAL IMMOBILIZER
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Crankshaft Sensor BROWN (-) AT PCM MODULE ON FIREWALL UNDER HOOD
PIN - 2Z
Camshaft Sensor BLACK/ WHITE (-) AT PCM MODULE ON FIREWALL UNDER HOOD
PIN - 2V
Speed Sense WHITE/ RED (-) AT PCM MODULE ON FIREWALL UNDER HOOD
PIN - 1J
Parking Lights BLACK/ WHITE (-) AT VEHICLE LIGHT SWITCH HARNESS
Brake Lights RED / WHITE (+) AT SWITCH ABOVE PEDAL
Reverse Lights GREEN/ BLACK (+) BROWN PLUG BEHIND GLOVEBOX
MAY ALSO BE GREEN/ ORANGE
Horn BLACK (-) IGNITION SWITCH HARNESS
Anti Theft RX GREEN/ RED (+) IGNITION SWITCH HARNESS
Anti Theft TX BLACK / YELLOW (-) IGNITION SWITCH HARNESS
Doorlocks/Windows
WIRE COLOR POLARITY LOCATION
Power Unlock GREEN/ RED (-) DRIVERS KICK
PIN - T, PLUG #6 MUST USE A RESISTOR FOR INTEGRATION
PowerLock GREEN/ RED (-) DRIVERS KICK
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
I was just looking at this post and Ted's reply. The wiring is uncannily close to that year's Euro Focus which isn't too surprising because they are the same car!
Two points:-
a) I thought it had a second ACC, yellow/black.
b) When the job is done, leave it for a couple of hours. See if the door or trunk contacts trigger the alarm when the car is just standing there. It's a "go to sleep" processor problem, this is the cure. Blocking diode on the + side of all dome and trunk lights, 1N4004, band towards light bulb.
thanks but im just doing a remote starter without alarm so i might not have to worry about the dome light or trunk light but thanks anyways for all the help
-------------
Confidence is the key to any project!!
If this mazda is a manual car, then yes you will have to worry about it, you will need to monitor all doors