no hole in h3 door for new wires?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119252
Printed Date: July 15, 2025 at 9:12 PM

Topic: no hole in h3 door for new wires?

Posted By: ozofoe
Subject: no hole in h3 door for new wires?
Date Posted: January 11, 2010 at 11:19 AM

2006 H3 Hummer: I'm trying to install a 530t window module in the driver's kick panel, and run wires into door.

The lock and window wires break via a wire harness in the door jam. This does not leave me a rubber grommet to make a larger hole, or a new hole to run the five new wires per window (RF, LF). I could drill a new hole in the door frame, but there might be an easier way.

This forum is knowledgeable and experienced so someone might have seen this on other GM vehicles.

Replies:

Posted By: chev104275
Date Posted: January 11, 2010 at 4:03 PM

is there i hard connector in the jamb ? if there is you can go through an open cavity in the connector

-------------
If i Can't Install it I Don't need it Joe

Posted By: KarTuneMan
Date Posted: January 12, 2010 at 10:53 AM

Lookie this!

Posted By: ozofoe
Date Posted: January 12, 2010 at 4:26 PM

Thanks guys. The pics in the link made it very clear what you're both saying.

Print Page | Close Window