’00 suburban won’t remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119288
Printed Date: May 15, 2024 at 6:21 PM

Topic: ’00 suburban won’t remote start

Posted By: w8lifter21
Subject: ’00 suburban won’t remote start
Date Posted: January 12, 2010 at 1:51 PM

I am so use to doing Toyota and imports, I hope this was a small oversight and simple fix.

Using XK06, it learned Passlock 2 resistance according to the LED flashes on the bypass.

-Car cranks and dies, dash displays "security" in yellow.

-I start the car with the key, press remote start(remote start takeover), and same thing, dash displays "security" in yellow.

-I just put the key in the ignition(I do not turn it) and try to remote start. Same thing, cranks starts for a split second then dies.(Don't remember if the security light came on or not)

I know I did not hook up the factory alarm disarm. I have been so use to doing Toyotas where OEM security turns off with keysense, that I just simply forgot.

Anyone else experience this with '98-'02 GM truck/SUV?

-------------
Refined Performance Motorsports

Replies:

Posted By: monty_77
Date Posted: January 12, 2010 at 3:30 PM

did you make sure that u did not connect the ground while running wire will programing it. if connected it can learn the wrong value if the starter has a trickle when not running.

Posted By: zerepdivad
Date Posted: January 12, 2010 at 3:42 PM

I'm gonna assume you didn't flash the unit to plxr 3.0?

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.

Posted By: w8lifter21
Date Posted: January 12, 2010 at 4:01 PM

Yes, the unit was flashed with the PLXR 3.0, and the the unit was programmed before connecting ground while running.

Little bits of information I left out my OP lol.

-------------
Refined Performance Motorsports

Posted By: zerepdivad
Date Posted: January 12, 2010 at 4:07 PM

I'd say reflash and try again. I've had to do that before with the xk06 module in the past.

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.