oem disarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119289
Printed Date: May 29, 2024 at 2:24 AM
Topic: oem disarm
Posted By: harleyrob
Subject: oem disarm
Date Posted: January 12, 2010 at 2:49 PM
installed a pro9776n with an fl-can module in a 2008 Dodge Ram 2500 diesel every thing works, except when you remote start the vehicle it sets off the factory alarm,any ideas on how to disarm the factory alarm?
Replies:
Posted By: zerepdivad
Date Posted: January 12, 2010 at 3:10 PM
Hook up keysense.
-------------
A DMM is a beautiful thing.
MECP Advanced Installer Certified.
Posted By: harleyrob
Date Posted: January 12, 2010 at 3:28 PM
I am using an idatalink it is hooked into the PURPLE / brown mux wire that is giving me door locks,door pins,brake signal,data/muxstarter control is supposed to give oem arm and disarm,but factory alarm triggers on remote start any ideas for a factory disarm wire?
Posted By: zerepdivad
Date Posted: January 12, 2010 at 3:33 PM
Yeah keysense. take apart your key so it's just hte plain casing and metal key and stick it in the ignition not turned. Then lock it wait for it to arm and you'll see the alarm will likely not go off. Therefore you will want to hook up keysense.
-------------
A DMM is a beautiful thing.
MECP Advanced Installer Certified.
Posted By: harleyrob
Date Posted: January 12, 2010 at 3:41 PM
keysense wire is the PURPLE / brown it is also the mux wire and it is hooked up I still trigger factory alarm on remote start
Posted By: zerepdivad
Date Posted: January 12, 2010 at 3:44 PM
did you hook up an 8.5k resistor on it and trigger it with factory disarm or status output? The modules don't ALWAYS do EVERYTHING.
-------------
A DMM is a beautiful thing.
MECP Advanced Installer Certified.
Posted By: harleyrob
Date Posted: January 12, 2010 at 4:26 PM
Sorry the module was supposed to give me OEM arm and disarm, Thanks for the resistor value that did the trick everything works fine now Thank You VERY MUCH!
|