factory alarm disarm with power probe 3
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119293
Printed Date: May 11, 2024 at 1:27 AM
Topic: factory alarm disarm with power probe 3
Posted By: hasnanajmal
Subject: factory alarm disarm with power probe 3
Date Posted: January 12, 2010 at 7:14 PM
Can someone please help me? im looking to disarm find the Disarm factory alarm wire without going into the door of my 2005 Acura TL. It says it's BLACK/ red to white I didnt see any White wire though. in order to find the wire do i put the power probe on different wires and turn the key to the unlock position in the key cylinder? What type of signal am i looking for from the disarm wire? Negative or positive?
Replies:
Posted By: Twelvoltz
Date Posted: January 12, 2010 at 8:39 PM
When you are on the wire you think is the correct wire, connect the probe to the wire, turn the key in door to the unlock position and your probe will show ground.
You have to go into the door to interface with the analog disarm wire. The only way to interface with the factory alarm without going into the door is to use a data module.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: hasnanajmal
Date Posted: January 12, 2010 at 9:43 PM
So basically what you're saying is that unless you have the Data Module I will have to go inside the door then? Will the wire be directly under the switch or somewhere inside the door? Is it a pain in the ass to look for it inside the door?
Posted By: another-kelly
Date Posted: January 12, 2010 at 9:56 PM
hasnanajmal wrote:
So basically what you're saying is that unless you have the Data Module I will have to go inside the door then?
yes
hasnanajmal wrote:
Will the wire be directly under the switch or somewhere inside the door? Is it a pain in the ass to look for it inside the door?
if memory serves correctly, it'll be in the harness that plugs into the power window switches in the driver's door
Posted By: howie ll
Date Posted: January 13, 2010 at 8:22 AM
Tedmund did a post on this recently, he found them INSIDE the car, contact him.
Posted By: tedmond
Date Posted: January 13, 2010 at 4:55 PM
yea i did, the 05 TL, i dont think the wiring is the same. I have the 09 accord, but then again the TL is an accord rebadged with extra goodies. Try looking high up in your dash, and lok for 4 square connectors that have dummy plugs on them. THere is a grey, blue and two white plugs. In the white plug, you should see VERY thin gauge wire. Its around 22 gauge if not more. If its the same as the 09 accord, it will be Orange and White. ------------- Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: Twelvoltz
Date Posted: January 13, 2010 at 5:00 PM
tedmond wrote:
Try looking high up in your dash, and lok for 4 square connectors that have dummy plugs on them. THere is a grey, blue and two white plugs. In the white plug, you should see VERY thin gauge wire. Its around 22 gauge if not more. If its the same as the 09 accord, it will be Orange and White.
Great information! Wish I would have seen it before last week!  ------------- Installer, IT support, and FFL. I need less hobbies.
Posted By: yimke
Date Posted: January 14, 2010 at 5:13 PM
That works without diode isolating the unlock detection wire?
Posted By: tedmond
Date Posted: January 15, 2010 at 5:55 AM
you will diode isolate the orange and white wires.
-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: yimke
Date Posted: February 06, 2010 at 7:07 PM
tedmond wrote:
you will diode isolate the orange and white wires.
Sorry to revive old thread, but wanted to update.
I tried this trick in an 06 accord today, could not find the right colored plugs, but I did have some extra time to start probing some plugs that looked similar that were dummy plugs. The were Green, light blue, and two white plugs high in the kick/behind the sunroof and VCA switches. Nothing, so I assume this trick only works on 08+ accords.
Also on those plugs can you grab re-arm as well?
Can you post a picture please Ted so I can compare where yours were at.
|