best way to splice into bcm pin location?
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119331
Printed Date: May 05, 2024 at 9:51 AM
Topic: best way to splice into bcm pin location?
Posted By: georgyop
Subject: best way to splice into bcm pin location?
Date Posted: January 14, 2010 at 3:29 PM
Hello,
I have instaled a few alarms over the past few years , but none where I have to splice into the BCM pins..... :errr:
I recently got a Scytek Astra 777 new in box, with a 2-way pager, and a few connections require pins 14,18, 20 and one other pin on the BCM in my Nissan 350Z.
My question is.... when the instructions say to splice this trigger or dome light supervisor to "BCM pin 60", are you supposed to take some insulation from the wire that goes to that pin, and solder your alarm wire onto that wire, or fit the wire tip into the pin?
I am looking for the best way to make the connection at the BCM pin locations. I know that I will solder, but not sure to what, a wire or a pin?
Thanks much in advance.
George
Replies:
Posted By: KPierson
Date Posted: January 14, 2010 at 5:32 PM