toad a101cl locking when disarmed
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119391
Printed Date: May 13, 2025 at 6:55 PM
Topic: toad a101cl locking when disarmed
Posted By: jack155q4
Subject: toad a101cl locking when disarmed
Date Posted: January 16, 2010 at 1:51 PM
Hi,
I have an A101CL installed. Tonight I have been changing a few settings. Firstly to stop the auto locking after about 20 seconds of the ignition being on, that worked fine. The other I was trying to change is the auto-rearm after a disarm.
This appears to work in the sense that the alarm will not arm any more but it locks the doors only.
So, if:
I press button 1. This arms the alarm and locks the doors.
Then, I press button one a bit later and it unlocks and disarms.
Then, after a bit the indicator light will start rapidly flashing and then after maybe a minute the doors will lock, the indicator light is now OFF. However, if I open the door with the actual key and get in I can start the engine and the alarm won't go off. It seems disarmed.
I can not find anything like this in the installation manual (bought from Abacus today).
I would appreciate some help with this.
Many thanks,
Jack
Replies:
Posted By: howie ll
Date Posted: January 16, 2010 at 2:43 PM
PM me with your email address I'll send you the programming sheet from the install guide.
Posted By: jack155q4
Date Posted: January 16, 2010 at 3:46 PM
howie ll wrote:
PM me with your email address I'll send you the programming sheet from the install guide.
PM sent. Thanks!
|