2009 dodge caravan wiring

Hi ,I have a 2009 Caravan and need help in installing a remote starter ,Does anyone have the wiring info for this vehicle.I have install remote starter on caravan before but this 2009 look way  different to me,i do some reading on this vehicle where  Vehicle wiring info show no connection need for starter, ignition, Accessory  wire for remote starting so i am wondering where will i connect these wire. Like i said i have done remote starter om many vehicle before but 2009 caravan is something new for me .Thanks in advance I need as many help as possible .Thanks guys

-------------
Chris

2 VOLT CONSTANT      RED ( +)      BATTERY     
STARTER      YELLOW/ GRAY ( + ) (NOT USED FOR REMOTE START)           
STARTER 2      N/A           
IGNITION 1      PINK/WHITE ( + ) (NOT USED FOR REMOTE START)           
IGNITION 2      N/A           
IGNITION 3      N/A           
ACCESSORY /HEATER BLOWER 1      DK.BLUE/PINK ( + ) ( NOT USED FOR REMOTE START)           
ACCESSORY /HEATER BLOWER 2      N/A           
KEYSENSE      N/A           
PARKING LIGHTS ( - )      WHITE (- THRU 1000 OHM RESISTOR)      HEADLIGHT SWITCH OR PIN 9 ,PLUG C2 AT INSTRUMENT CLUSTER     
PARKING LIGHTS ( + )      LT. BLUE (LEFT) ( + ), WHITE/ PURPLE (RIGHT) ( + )      DRIVERS KICK     
POWER LOCK      PURPLE / DK.GREEN (- THRU 330 OHM RESISTOR)      DRIVERS KICK , OR CONNECT LOCK AND UNLOCK AS TYPE ''B'' NEG. TO CHALL MODULE     
POWER UNLOCK      ONE WIRE, SAME AS LOCK (-THRU 100 OHM RESISTOR)           
LOCK MOTOR WIRE                 
DOOR TRIGGER      PURPLE ( - )      DRIVERS KICK     
DOMELIGHT SUPERVISION      YELLOW/PURPLE ( + )      DRIVER A PILLER OR PIN 4, PIN 4, AT INSTRUMENT CLUSTER, PLUG C2     
TRUNK RELEASE      CONNECT TO TRUNK WIRE ON CHALL MODULE           
SLIDING POWER DOOR      N/A           
HORN      DK.GREEN/ VIOLET ( - )      AT HORN SWITCH OR PIN 10 , PLUG C3, AT INSTRUMENT CLUSTER     
TACH      NOT BROWN / WHITE (AC)      ANY FUEL INJECTOR     
WAIT TO START LIGHT      N/A           
BRAKE      WHITE/ DK.GREEN ( + )      AT SWITCH ABOVE BRAKE PEDAL     
FACTORY ALARM DISARM      DISARMS WITH IGNITION AND TRANSPONDER SIGNAL           
ANTI-THEFT      TRANSPONDER TYPE      MUST USE A CHALL INTERFACE MODULE

chall bypass.

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.

x1le ,Thanks for your reply  but where will i connect the Starter ,Ignition and Acc wire any help will be great for me. thanks

-------------
Chris

naresh1912 wrote:

---

x1le ,Thanks for your reply  but where will i connect the Starter ,Ignition and Acc wire any help will be great for me. thanks

---

Take a look at the install guide. https://www.bypasskit.com/getdocument.aspx?documentid=1815

The wires in question are connected to the bypass module.

Thanks for the help guys i will give it a try and see what will happend ,if anyone have anything to add it will bebig help for me. Thanks once again you guys are great

-------------
Chris

Here is another option for a remote start in the Caravan.

https://www.the12volt.com/installbay/forum_posts.asp~TID~118417~PN~1

-------------
Soldering is fun!

Use the Idatalink bypass, makes this van a lot easier....

-------------
Mike M2
Tech Manager
CS Dealer Services

I did a few of them using the Fortin EVO-CHR and within 20 minutes I was done. Plug and play for the most part except constant, ground and ignition along with the parking lights.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA