How's it going? I have a 93 Jeep Wrangler YJ that I've been building for 2yrs from the ground up. It has a Chevy 4.3Vortec out of a 03 Silverado. The Jeep is nearing completion, hopefully within a year, and is time for the alarm before I tape and secure all of tlhe wiring. I decided on the Viper 5902 with a proximity, tilt, and maybe a glassbreak and batt backup. This is my first alarm/remote start install, but am very well rounded when it comes to electrics. I spent weeks in diagrams and wiring to transplant the Chevy PCM into the jeep harness and made new harnesses.
Some wiring history on the Jeep. It has painless relays (6 banks) that control fuel pump, starter, horn, backup lights and some other lights. The relay banks are constant hot. It has a 7 circuit aux fuse box that runs the Chevy PCM. 4 circuits ign hot, 3 circuits constant hot.
The jeep has half doors, so no doorlocks to worry about. Has a 5spd manual transmission.
I've looked online at the install guide for the 5901, but that only clears of about 70percent of the install. What I really need is a diagram or operation layout so I can see what needs power or grounds at what point.
Oh and the only problem i have in my wiring on the engine install is the ign switch. Turning the key to start position you get nothing because the start relay looks for a ground off of the PCM and the jeep ign doesnt provide this..no big deal...i could either wire it differently to work with the jeep ign or use a push button start.
Any advice or actuall diagrams for the 5901 or 5902 would greatly help. Thanks in advance
look in the downloads section of the site i know the installation manuals are there