Ok i have had the 530t installed for my truck for over a year and never had any problems with it until now..for some reason my driver window will only roll up and down in sections. My passenger window still works fine. I have the one-touch operation on the driver side that operates both windows up and down. In order to get the driver window down, i have to keed tapping the switch. (same when rolling up). Does anyone know what the problem could be?? I have the door panel off and the 530t is in hands reach. Any help is greatly appreciated. Thanks
-------------
Scott
spray some w40 on the window rail to loosen any dirt,then clean the inside fo the rail with a cloth. if the window detects resistance it will stop, thinks something is jammed hope this helps.
-------------
rocker
ok i tried cleaning the track and everything with the wd-40 but i had no luck...however i started messing with the 530t module while i was out there, and i started to play around with the "dipswitches" when i put switch 2 (which is driver side setting) to the down position, my auto roll-down works but only going down. When i roll it up, i still have to tap it as it goes up a little each time. Maby this narrows out some of the problems...any more suggestions? The only thing wrong now is the auto roll-up. Thanks for the help!!
-------------
Scott
Cleaning the track with WD40 was a good start.
Since WD40 is not a lubricant put a penetrant, I would follow up with silicone spray or white lithium grease on the window track, especially down low on the track behind the interior door panel.
After that, I would do the resistor mod trick on the 530t.