Print Page | Close Window

omega chdl4 p connection?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120125
Printed Date: May 19, 2024 at 12:14 AM


Topic: omega chdl4 p connection?

Posted By: shafferny
Subject: omega chdl4 p connection?
Date Posted: February 14, 2010 at 4:09 PM

Hi everyone.

I'm in the process of installing a remote car starter in my 2003 Jeep Liberty and I'm using a Omega CHDL4-P interface to integrate it into the vehicle. The problem I'm having is that I can't find the pink/violet wire  in the C2 connector of the body control module. According the instructions it should be pin 10, but pin 10 is RED / green. According to the factory service manual I have the RED / green wire is the "front wiper switch mux".

All the other wires are exactly where the instructions state. Can anybody help me out here?

Here is the instrustion sheet. https://www.caralarm.com/manuals-install/Interface%20Modules/DB-CHDL4P.pdf

TIA




Replies:

Posted By: shafferny
Date Posted: February 14, 2010 at 4:32 PM
I think misinterpreted the instructions. The PK/VT wires is not in the C2 connector at the BCM, but at the C2 junction block connector.


Print Page | Close Window