cant get into programming c3 rs665
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120216
Printed Date: November 03, 2025 at 9:02 PM
Topic: cant get into programming c3 rs665
Posted By: azboy
Subject: cant get into programming c3 rs665
Date Posted: February 18, 2010 at 2:16 PM
I just installed an autopage c3-rs665 into my 98 silverado. I cannot get remote start to function because I cannot get into the programming function no matter what I try. I am very mechanically inclined and have installed alarms before so I know the alarm is installed properly"I hope". All I get when I try to enter programming after on off 3 times then pressing the button 9 times is one chirp and thats it no matter what. The led is constantly blinking 4 times when the alarm is off which is puzzling me as well. I have the safety switch grounded and everything else done properly I think and this is not a very advanced vehicle so I just cant figure out where my problem lies and any help would be greatly appreciated thanks....
-------------
azboy
Replies:
Posted By: calijtee1
Date Posted: February 18, 2010 at 10:05 PM
do you have the hood pin open by any chance you need to have it open in order for it to go to programming and the autopages are a lil trickier thsan most alarms i also once in a while i have a run in with these auto pages .
-------------
installers do it best. we got the magic hands!
Posted By: azboy
Date Posted: February 23, 2010 at 9:37 AM
well figured the issue out finally....
I had used those connectors that you crimp to wires to connect them instead of using solder...big mistake obviously so I had went wire to wire re-doing each wire securely soldering each one and after doing this my problem was solved and everything functioned properly...One of the wires or more must have not gotten a good connection from the connectors that I had used but all is good now...so if ur having issues make sure everything is soldered securely
|