ford fiesta 2009 mk7 color codes
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120316
Printed Date: July 06, 2025 at 8:14 AM
Topic: ford fiesta 2009 mk7 color codes
Posted By: the12voltuser
Subject: ford fiesta 2009 mk7 color codes
Date Posted: February 22, 2010 at 4:11 PM
hi
I need the color codes or the wiring diagram to connect the alarm to New Ford Fiesta MK7
Thanks to all
Replies:
Posted By: tedmond
Date Posted: February 22, 2010 at 4:20 PM
howie? not sure what the NA equivalent is. If i did i would post up wire info for you.
------------- Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: howie ll
Date Posted: February 22, 2010 at 4:32 PM
No info, only done a tracker and played around with the head unit, managed to bang my head on the steeply raked windscreen getting in and out. Everything's behind the glove box, test.
I can give you the colours on a new Hyundai Getz whatever that is, needed a bloody driver's door actuator, couldn't find any cable entries from the engine bay, went over the wheel arch into the space between the front door and the body, found a convenient entry grommet, everything else bar power goes behind and connects to the instrument cluster.
Posted By: the12voltuser
Date Posted: February 22, 2010 at 4:44 PM
thk
my problem is that I connected the alarm, but since there the original perimeter alarm, go into conflict, because if I close with the new alarm, and then unlocked, the original alarm sounds.
Posted By: tedmond
Date Posted: February 22, 2010 at 4:50 PM
the car should have a factory alarm disarm wire somewhere. can you turn off the factory alarm by turning a key in the door? if you can time to rip open the door panel and start testing. ------------- Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert
Posted By: the12voltuser
Date Posted: February 22, 2010 at 5:07 PM
even if the original alarm is disabled when I open the door (if it's on the new) sounds activate.
The problem is that some kind of disconnect from the cable, and I have no key to turn it off, I was given, I might look for the positive cable and seconded to know where he is!
but there can be both?
thk
Posted By: howie ll
Date Posted: February 23, 2010 at 12:57 PM
Probably needs a stealership to turn it off via the diagnostics.
Posted By: the12voltuser
Date Posted: February 23, 2010 at 3:27 PM
I understand, but do you think the anti-theft perimeter is maintained only by the original GEM? Or is there an additional unit? because I can not find it, follow the installation instructions of the Ford!
|