This Is A Good Question About Sirens
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12032
Printed Date: August 25, 2025 at 1:18 PM
Topic: This Is A Good Question About Sirens
Posted By: CruisinS&S
Subject: This Is A Good Question About Sirens
Date Posted: April 10, 2003 at 1:06 PM
Hey I was trying to get everyones attention. Does anyone know how to change a multi tone siren to sound only one tone? Any help would be great
-------------
Cruisin Security And Sounds
Replies:
Posted By: themagicone
Date Posted: April 10, 2003 at 1:16 PM
If its dei, you can open up the back and cut the loops - not the big one hanging out but some small ones in side. Each loop conrtolls a tone so cut as many tones as you want off.
Posted By: sufferrar
Date Posted: April 10, 2003 at 1:18 PM
You have to open it up and look for about 6 traces coming off an i.c. on the circuit board.Cutting each trace will remove each sound.try one at a time.
-------------
"I'm So Loud It Hertz"
Posted By: ksachet
Date Posted: April 10, 2003 at 4:10 PM
I have done this on my DEI alarm and it works great for removing those stupid tones that you don't want. Be careful not to cut the long loop that hangs out. if this is cut it kills the quiet arm and disarm tone and will now arm and disarm at full blair. If this is what you want. then cut this loop.
|