autopage rs665 to idatalink wires

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120384
Printed Date: July 02, 2025 at 5:34 AM

Topic: autopage rs665 to idatalink wires

Posted By: dwljpl
Subject: autopage rs665 to idatalink wires
Date Posted: February 26, 2010 at 5:48 PM

I have an Autopage RS-665 remote start that I'm going to wire to an idatalink DLSL-GM bypass and I'm wondering if I need to hook the disarm and rearm wires from the remote start to the bypass or if I hook the lock and unlock wires to the bypass instead. If that's the case do I need to diode isolate the lock and unlock wires so it's not feeding +12 volts into a negative input?

Replies:

Posted By: tommy...
Date Posted: February 26, 2010 at 9:50 PM

Most of these newer bypasses do factory disarm/rearm through data...etc......WHAT kind of CAR...! Its kinda hard to lead you in any direction w/o the most important part...THE CAR...?

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!

Posted By: dwljpl
Date Posted: February 26, 2010 at 10:07 PM

Sorry, it's a 2004 Pontiac Grand Prix.

Print Page | Close Window