crimeguard 750i6 on 2010 tacoma
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120564
Printed Date: October 31, 2024 at 7:38 PM
Topic: crimeguard 750i6 on 2010 tacoma
Posted By: cjastacio
Subject: crimeguard 750i6 on 2010 tacoma
Date Posted: March 07, 2010 at 12:56 AM
Hi all,
I'm working on my install and will pick up tomorrow. I have all the wires sorted right now except the domelight supervision wires. I'm really confused about these two wires on the Crimeguard alarm. According to the manual, I can connect the GREEN/ violet wire(supervision output) to the door trigger connection that I use. This seems easy enough, just connect the door trigger and GREEN/ violet wire to the same wire. But where I get confused is on the connection of the BLACK/ red(supervision input) wire. Is this supposed to be connect to the same wire as above or somewhere else?
Another question that would totally nullify the above question is do I even need to connect these wires at all? The factory keyless entry already turns on the domelight on unlock. That being said, all I really need to worry about are my lock/unlock connections as these functions control the domelight as well. Am I right here?
Replies:
Posted By: cjastacio
Date Posted: March 07, 2010 at 11:11 PM
Ok, so I asked crutchfield and they confirmed that I don't need to use the domelight supervision because of the factory keyless already working with domelight supervision. So once I have the keyless for the crimeguard is connected domelight supervision will work. They also told me that IF I still wanted to use the domelight supervision capabilities is the crimeguard, I would connect the GREEN/ violet wire to door trigger and the BLACK/ red to ground.
On another note, I have been trying to find the lock and unlock cables in my truck. I have the wire list but it only says to look for them in the white plug in the driver's kick panel. Well, there are a number of white plugs in the driver's kick panel! Does anyone know where I can find documentation which would tell me EXACTLY where to find the lock/unlock wires?
Posted By: Mike M2
Date Posted: March 08, 2010 at 6:27 PM
Follow the wires coming in from the rubber door boot, they travel down to 2 plugs that are not mounted in the kickpanel but are simply loose. The wires on each side of these plugs are covered in black plastic. You'll find them there...
-------------
Mike M2
Tech Manager
CS Dealer Services
|