Print Page | Close Window

dlpkgm programming

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=120588
Printed Date: May 15, 2025 at 3:33 PM


Topic: dlpkgm programming

Posted By: kencat21
Subject: dlpkgm programming
Date Posted: March 08, 2010 at 11:54 AM

Hello, I recently purchased an dlpkgm and clifford 50.7x. I have been trying to program it to a 2000 Jeep Grand cherokee using D2D.

When I first tried to program it, I didn't realize I had to change the jumper settings on the 50.7x. So I tried to program it over and over to no avail.

Now that I have changed those settings, it still is not programming.

I have the power, ground and siren wired on the alarm and tach sense from the dlpkgm. I followed plan 6 and have the pink and pink/white wired to the non transponder side of ignition and the pink/black wired to the transponder side. And I have the purple data output wired to the yellow/purple wire from my car.

I noticed that in the manual it states that chrysler vehicles can only be programmed 5 times max. Could that be the problem? Is there any way around that? Any help would be greatly appreciated.



Replies:

Posted By: buddholly
Date Posted: March 10, 2010 at 1:00 PM

I do believe the DLPKGM will only do door locks, tach and a couple of other things.  You probably need a different interface module, an XK01 should work.




Posted By: kencat21
Date Posted: September 04, 2010 at 11:26 PM
any more insight about the chrysler programming limitations?


Print Page | Close Window