Print Page | Close Window

need relay wiring for defroster, seats

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121244
Printed Date: May 14, 2024 at 1:10 AM


Topic: need relay wiring for defroster, seats

Posted By: monty862
Subject: need relay wiring for defroster, seats
Date Posted: April 09, 2010 at 7:25 AM

Could someone tell me how to correctly wire a relay for a negative trigger defroster and heated seats. I would like to have the rear defroster and heated seats be activated by the viper 5901 when needed (below 50). I've seen where some have wired directly to the defroster wire, but I think a relay would be required if triggering two seats and the defroster. Especially if latched. And I believe all three wires from the push buttons should be diode isolated with the bands toward the viper. Correct? Thanks in advance.

-------------



Replies:

Posted By: x1le
Date Posted: April 09, 2010 at 7:35 AM
Bands on the diode towards the viper, correct.

A relay would be wired like this.

85 - status outpit
86 - 12v
30 - ground
87 - defroster outputs




Posted By: monty862
Date Posted: April 09, 2010 at 10:28 PM
; Thanks!  I've heard of some relays having a diode to avoid a voltage spike. I don't need one of those do I? Thanks again.

-------------




Posted By: tedmond
Date Posted: April 10, 2010 at 6:15 AM

any relay will do, you can just add a diode across the terminals later on.

the correct way of doing this is

85 - defroster output aka second status
86 - constant 12v
87 - constant 12v fused at 15 amps
30 - connect one wire off and place 2 diodes inline, bands on diodes towards relay, then from each relay, one will go to defrost, one will go to heated seats.



-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert




Posted By: monty862
Date Posted: April 10, 2010 at 11:56 AM
Thanks Ted,  I've got two separate buttons for heated seats. One for drivers, one for passenger. Won't I have to use separate wires for each to retain individuality in normal use? And to reiterate, this is a Neg. trigger system. Doesn't one of the relay contacts have to go to ground to give it a "heavier duty" ground than the status output wire?  Thanks for the reply.

-------------




Posted By: tedmond
Date Posted: April 10, 2010 at 4:41 PM

sorry bout that. thats what happens when i post too early in the morning

85 - defroster output aka second status
86 - constant 12v
87 - chassis ground
30 - connect one wire off and place 3 diodes inline, bands on diodes towards relay, then from each diode, one will go to defrost, one will go to each of the heated seats.



-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert





Print Page | Close Window