immobilizer bypass, 2004 honda pilot

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121369
Printed Date: May 14, 2024 at 7:44 PM

Topic: immobilizer bypass, 2004 honda pilot

Posted By: tkmech21
Subject: immobilizer bypass, 2004 honda pilot
Date Posted: April 16, 2010 at 1:50 AM

First of Hello to everyone.

Ok I installed a clifford 50.5 on my 2004 Honda Pilot, I figured out that my vehicle has an immobilizer So I bought the Directed 556HW. In the instructions It does not list my specific year, it only lists 2003 pilot (the first year the Pilot was made) In the instructions it lists my system as the "Mode 2 type" https://www.directedstore.com/manuals/556HW.pdf My Question is on page 3 it has a layout of the wiring showing the use of Data 1, Data 2 and Ignition in the ignition harness. Page 4 lists the wiring specific to the Pilot BROWN / yellow-negative, Red-data1, yellow/black-ignition. It does not list a Data 2 wire. Also it shows the green wire going to pin connection 1, where might I be able to get a pin for that plug? There is no wire connected in possition 1 of the plug. Any help would be appreciated. Thanks in advance.

Replies:

Posted By: tedmond
Date Posted: April 16, 2010 at 6:19 AM

Red pin 2 - DATA

Blue pin 3 - Synchro

Yellow/black - ign

BROWN / yellow pin 4 - ground

wire as themanual says to, but use the colours mentioned above. leave it in mode 2.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: tkmech21
Date Posted: April 16, 2010 at 10:04 AM

So the Blue/synchro is my data 2?

And the RED / data 1 is the one i'll be cutting?

Posted By: tedmond
Date Posted: April 16, 2010 at 5:55 PM

refer to your install guide. just dont use the colours they mention there, and use the ones posted above.

synchro is basically data 2.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: tkmech21
Date Posted: April 16, 2010 at 11:32 PM

tedmond wrote:

refer to your install guide. just dont use the colours they mention there, and use the ones posted above.
synchro is basically data 2.

Thats what I wanted to clarify, That "data 2" was the same as the synchro you mentioned, Thank you Tedmond.

Posted By: tkmech21
Date Posted: April 17, 2010 at 8:29 PM

succesfully got my bypass installed, and RS working, Thanks again.