priority unlock w/ ads al on 07 escalade?

Can the ADS-AL CA do priority unlocking on this car? I have the Unlock/Disarm wire from the bypass (Blue/Black) hooked to the Factory Disarm output on the 5701 (Light GREEN/ Black). But when I disarm, only the drivers door unlocks, and pressing disarm again just unlocks the drivers door again. So is this a wiring/programming issue or does this bypass not support priority unlocking?

Thanks!

There is an old post listed under topic search here on 12volt.. it is titled "2007 escalade alarm/ remote start wiring" There are some tidbits that might be useful. The h2/6 light blue wire of the 5701 is used for second unlock function. Unfortunately it looks like Escalades are on separate door circuits front, rear and passenger. Sounds like a headache.

Here is something from the DEI 5701 install guide..which you can also download off 12volt under downloads.

h2/6 -200ma light blue

This wire produces a (-) 200mA output for progressive locks in which the driver door unlocks first and the remaining locks will unlock with a second press of the unlock button on the remote.
Note: This feature will need to be programmed “On” to function correctly (see System Feature Menu #1, feature 8)

I see where the alarm supports the secondary unlock but my question is if the bypass supports it? In the bypass instructions I only see one wire that mentions unlocking or disarming at it doesn't appear to do the progressive unlock.

I think I've seen the priority unlock on the DEI bypass for this vehicle so I'm surprised if this one doesn't have it. If not, I guess I can hardwire it but I'd prefer to do it through the bypass.

forget it. unlock all same time.

or hookup 2nd unlock wire to blue unlock wire. when you disarm 1 st time unlocks driver door. you have less than 2 seconds to hit disarm again to do all door locks. This is assuming your module was flashed properly and programmed properly