Print Page | Close Window

Avital 3200

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12228
Printed Date: August 16, 2025 at 1:17 AM


Topic: Avital 3200

Posted By: n8120b
Subject: Avital 3200
Date Posted: April 14, 2003 at 10:57 PM

hey there,

I am installing a Avital 3200 on a 2002 dodge neon. The unit starts my car ok  most of the time but about 25% of the time the starter will crank and then the engine stops.  I understand the maybe the unit has trouble reading the tach wire correctly.  I tryed to make it  "learn" the tach wire as in the instructions but it doesnt learn it.  

What I want to try is to make the unit read voltage sense instead of the tach wire, I am trying to reprogram it as in the instructions but the unit does not want to reprogram, in fact I cant even get past the first step.   The LED doesnt lite up to start up the programing process.

Could my wiring be wrong, because I really dont know anymore.

Please help,

Mac




Replies:

Posted By: profuse007
Date Posted: April 14, 2003 at 11:21 PM
let see if i can help you.
you sayin that you cant get the first step, i think you probably sayin the first menu.
so here i go.
-hold down the valet button down (takes about 5 seconds before it chirp or blink) until it chirp(chirp or light blink/ doesnt matter) 2x that mean youre in menu 2
-then let valet button go. press twox then press again but hold it down this time and it will verify that youre
-youre now in feature #2- voltsense/tach
-while holdin press unlock to go to pick voltsense. light or chirp will do 2X




Print Page | Close Window