gmc / isuzu truck remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122464
Printed Date: May 10, 2024 at 3:39 AM
Topic: gmc / isuzu truck remote start
Posted By: nelson_alc
Subject: gmc / isuzu truck remote start
Date Posted: June 28, 2010 at 10:35 PM
Hello I have problem installing a Viper 5901 to a GMC (Isuzu) Truck W5500 Diesel (Big commercial truck)..
The problem is that I have found all the wires correct for the remote starter (12v, Starter, Ignition, Accessory) but the truck try to start and do not stay on or stay on but shaking like there is no gas.
In the ignition switch there is 3 more wires:
Blue - Rest in ground and send 12v when you open the ignition for 1/2 a second and go back to ground.
Blue/white - Rest in 12v and go to ground when you open ignition.
Blue / YELLOW- Rest in ground and go to 12v when you open ignition.
All of this wires are in the ignition switch.
Everything in the installation of the alarm is correct I think that this have something to do with the glow plugs or something else..
I already try opening this wire or closing it with relays in the wires in the harness but no luck.
Thanks any of you for your help...
Replies:
Posted By: Velocity Motors
Date Posted: June 29, 2010 at 7:24 AM
What does each wire do when you have it in the crank position?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: nelson_alc
Date Posted: June 29, 2010 at 3:07 PM
In the crank position the blue wire stay in ground, the blue / YELLOW in 12v and the Blue/White in Ground, They only change in the on position but not in the crank position.
|