2010 tundra reverse wire, xk05 programming
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122486
Printed Date: April 23, 2024 at 1:33 PM
Topic: 2010 tundra reverse wire, xk05 programming
Posted By: dannyDEI
Subject: 2010 tundra reverse wire, xk05 programming
Date Posted: June 30, 2010 at 10:27 AM
Ok 2 quick questions.
1. Where can I find the reverse wire on a 2010 toyota tundra double cab?
2. I bought the XK05 bypass and was told 2 keys are required however the instructions dont mention the second key. They basically say wire it, connect it, turn the key to ign and the red light on the bypass turns solid, start truck with key, the solid red light goes out and the bypass is programmed. Where do you use the second key?
Replies:
Posted By: Mike M2
Date Posted: July 01, 2010 at 6:11 AM
It's a blue wire in the passenger kick panel.
Don't know the XK, but i have never seen a bypass in a Toyota need two keys.... ------------- Mike M2
Tech Manager
CS Dealer Services
Posted By: kreg357
Date Posted: July 01, 2010 at 6:58 AM
What firmware is loaded on the XK05?
I have used and prefer the 5.PKTI firmware ( over the PKT2 firmware ) on earlier Tundra's. It is an easier install and works great. Either way you should need only one working key. ------------- Soldering is fun!
Posted By: ajstetler
Date Posted: July 03, 2010 at 11:23 PM
I prefer the PKALL over the XK05...
-------------
Big Al
Posted By: jmsounds
Date Posted: July 12, 2010 at 1:10 PM
i don't know about you guys but i had a problem with a 09 tacoma when programing the module would not program i though i was doing something wrong i try a differente module same thing then i call tech support and they told that that some toyotas you have to try different keys if it does not work i did this and it work but only happened once
but to program you only need one key if the first does not work try a second key hope it helps
Posted By: Mike M2
Date Posted: July 12, 2010 at 2:17 PM
You cannot use the gray valet key....
-------------
Mike M2
Tech Manager
CS Dealer Services
|