passlock 2 and xk01 issues.

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122493
Printed Date: May 11, 2024 at 5:38 AM

Topic: passlock 2 and xk01 issues.

Posted By: tailz
Subject: passlock 2 and xk01 issues.
Date Posted: June 30, 2010 at 11:35 PM

I have a gmc sierra 2004. I just now got done wiring the 5901 up and the xk01. I started the truck with the actual key and it was fine. I unlocked and locked the doors and those worked fine. But when I try to remote start the truck it tries starting up and dies immdiatly with the car security light flashing

Does anyone have any suggestions on this weird mishap?

Replies:

Posted By: kreg357
Date Posted: July 01, 2010 at 7:10 AM

Did you set the XK01 ( w/AMDL firmware) to vehicle Type 4 when programming it to the truck? And did the XK01's red light follow the install guides programming sequence?

-------------
Soldering is fun!

Posted By: brent w
Date Posted: July 01, 2010 at 2:08 PM

try remote starting it with the factory key in the ignition. If that works, then the problem is in the xk01(install or programming)

Posted By: tailz
Date Posted: July 01, 2010 at 4:47 PM

I figured it out. I for some reason got the orange wire (Disarm) mixed up with the ground when on wire. My status output on the 5901 was connected to tthe orange wire hence why it sorta worked lol.

Posted By: ajstetler
Date Posted: July 03, 2010 at 11:20 PM

brent w wrote:

try remote starting it with the factory key in the ignition. If that works, then the problem is in the xk01(install or programming)

Actually this wont work since there is no chip in the key, just to help you in the future. Passlock 2 systems are a bit different...

-------------
Big Al

Print Page | Close Window