Print Page | Close Window

xro9100 program mode lockout

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122540
Printed Date: October 31, 2024 at 6:13 PM


Topic: xro9100 program mode lockout

Posted By: 1phatboy
Subject: xro9100 program mode lockout
Date Posted: July 05, 2010 at 9:55 AM

Finished installing an xro9100 into a 1999 Ford F-350 diesel with remote start. Everything went as expected and the system is working fine, with two exceptions, the timing setting for the wait to start timer and crank time. I want to change them a bit (crank longer and shorten the wait to start). When I try to go back into the program mode, the control unit will not let me back in. The valet switch is working, when I hold it in for three seconds it pages the remote. When I turn the ignition on and press the valet button three times, nothing...

Any thoughts?




Replies:

Posted By: 1phatboy
Date Posted: July 05, 2010 at 10:24 AM

My deepest and most humble appologies guys (and gals).. After checking my connections, I noticed that the ignition #1 wire had broken contact.... Everything is just fine!! Can't remove post as I am a rookie, an posted_image rookie at that!!

I know, check connections, check connections, check connections....

posted_image






Print Page | Close Window