no momentary button on viper 300 alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122679
Printed Date: May 13, 2025 at 12:11 PM

Topic: no momentary button on viper 300 alarm

Posted By: mejia2
Subject: no momentary button on viper 300 alarm
Date Posted: July 13, 2010 at 11:34 PM

I have a 95 chevy astro with a Viper 300 alarm I need to program the remote but I found there is no momentary button to enter the codes. Does anyone know what i need to do to program my remote???

-------------
raul

Replies:

Posted By: KPierson
Date Posted: July 14, 2010 at 5:20 AM

You will have to access the button. If your installer did not put it in you will need to either buy one or make your own. There should be a 2 pin blue port on the brain that needs to be shorted out each time the button is pressed.

-------------
Kevin Pierson

Posted By: itsyuk
Date Posted: August 09, 2010 at 12:59 AM

i have a really really old 300 that uses the gray wire hooked to the valet switch. it was made before the days of blue port.

its kinda funny.. the installation instructions were a single piece of paper about 5x7 inches.

remote had about a 35 foot range.

-------------
yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.

Posted By: flhunter
Date Posted: August 09, 2010 at 2:55 AM

Use the valet switch to program. just toggle it on-off. This is the same as to push momentary button.

Print Page | Close Window