Print Page | Close Window

2002 sentra specv remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122690
Printed Date: May 10, 2025 at 8:31 PM


Topic: 2002 sentra specv remote start

Posted By: hdriscoll
Subject: 2002 sentra specv remote start
Date Posted: July 14, 2010 at 5:56 PM

I'll soon be installing a Viper 5101 RS into my 2002 Nissan Sentra SER SpecV.

My question is with the door locks and factory alarm disarm and rearm. I know how to use the GREEN/ blue wires from the RS to control door locks, but how do I connect the H2/6 light blue 2nd unlock wire? The H2/1 light-GREEN/ black wire is for factory disarm and goes to pin 30 of the "smart entrance unit". This pin is for the key cylinder switch (unlock). Can I also use the rearm wire and connect it to pin 40 which is the key cylinder switch (lock)? Will I need to use H1/9 BLACK/ white "dome light output"? Won't the car turn on the dome lamp when I unlock it with the Viper remote? I have the factory wiring diagram, so finding wires won't be a problem.

Thanks for any help. I've installed a bunch of alarms and remote starts, but they were basic installs.




Replies:

Posted By: hdriscoll
Date Posted: July 14, 2010 at 6:02 PM
Sorry, I meant pin #41 is rearm. I'm not able to edit my posts yet.



Posted By: hdriscoll
Date Posted: July 15, 2010 at 8:12 PM

So, no thoughts on the wiring?

 I looked at the wiring diagrams again and it looks like I can use pin 13 "door unlock DR" and pin 14 "door unlock OTHER" at the smart entrance contol unit. I'll need relays as these wires go straight to the actuators.

Any way of doing it without relays?


Print Page | Close Window