07 camry remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122792
Printed Date: April 29, 2024 at 8:13 PM

Topic: 07 camry remote start problem

Posted By: SoundFX411
Subject: 07 camry remote start problem
Date Posted: July 22, 2010 at 9:09 PM

I installed an Omega AL-1920EDP in a 2007 Toyota Camry. Everything works fine except I cant get the Immobilizer ring around the ignition to work. If I put the key in the ignition the car will start but take it out and just a crank.I used a DEI 556U and I also used the Omega method by wraping the ignition 5 times and no good. Any help please

-------------
SoundFX

Replies:

Posted By: xxunknownxx
Date Posted: July 22, 2010 at 10:12 PM

Make sure you have the keysense wire connected. That may prevent it from staring.

Posted By: tedmond
Date Posted: July 23, 2010 at 5:49 AM

should have used a data based bypass. much more reliable than key in the box.

the toyota immobilizer ring is very sensitive as to where it can receive the RF code. you will just need to trial and error until it works. then tape it down or zip tie it.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: Mike M2
Date Posted: July 23, 2010 at 6:12 AM

Ted is right, you need to get the ring ring at the front edge of the cylinder on this car. Also, feel your keybox. You should feel the relay inside click when it comes on....

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: SoundFX411
Date Posted: July 23, 2010 at 6:14 AM

Thank You . Im going to pick up a Data link and use it . I found it on the site..Once again Thank You

-------------
SoundFX

Print Page | Close Window