Print Page | Close Window

viper 5701 override switch number

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122862
Printed Date: July 06, 2025 at 2:10 AM


Topic: viper 5701 override switch number

Posted By: eg2kiwi
Subject: viper 5701 override switch number
Date Posted: July 27, 2010 at 5:54 PM

Hi,

   Just got this alarm refurbished from ebay and it's giving so many problems. The problems I have is that the LED on the antenna switch don't work (used a different LED and it does work from the unit)...

The Failsafe Stater Kill don't work and the wires are hooked up correctly.

If you guys have an answer to the top questions will appreciate. But what I am looking for is this:

--------------------------------------------

System override
To disarm the system without a remote control:
You will need to use your Override Switch located on your systems
control center (see diagram below) to disarm the system. The Override
Switch disarms the system only if you have the vehicle key.
To check proper operation:
Open the door. The alarm will sound.
Immediately insert the key into the ignition and turn it to the RUN or
ON position. (all the indicators in the dash will turn on).
Press the Override Switch once.
Note: The Override Switch feature allows you to select a specific
number of presses needed to disarm the alarm. If the Override

Switch has been programmed to a new number of presses by your
authorized dealer, that number should be indicated below.

--------------------------------------------


What is the # of clicks from the factory? and how can I change the number of clicks? can't find anywhere on the manual.

Thank you for your time.



Replies:

Posted By: tedmond
Date Posted: July 27, 2010 at 7:00 PM

I think the default presses is 1



-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert



Posted By: tedmond
Date Posted: July 27, 2010 at 7:05 PM

are you sure the start kill is wired correctly?

the starter wire is cut and Violet to starter motor, Green to ignition cylinder.



-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert



Posted By: t&t tech
Date Posted: July 28, 2010 at 6:36 AM
And the pink must see true ignition, just to be sure, since we have a poster a few posts down who made a whole story of his rx-7 with a similiar problem!

-------------
COMMIT YOUR WAY TO JEHOVAH AND HE WILL ACT IN YOUR BEHALF. PSALMS 37:5


Print Page | Close Window